M1 analog
Adjustable voltage mapping · calibrated signal, not physical travel
M1 signal
UnavailableCurrent reading
State
Connect V26 or V27 for real M1 ADC readings. Higher-voltage inputs require V27.
ADC hardware settings appear after connection.
Raw ADC: unavailable
Calibration
Set the signal at rest and full press. Reversed polarity is supported. Changes stay draft until explicitly applied.
Accept readings across the nominal 3.6 V ADC range without changing your full-press point. This is a software cutoff, not a supply setting: the physical input must stay within the actual pin supply (VDD). ADC saturation still faults. Never connect 5 V.
V27/V28 support adjustable reading ceilings; V26 stays limited to 1.8 V. Changes are draft until applied.
Rapid trigger
Relative release and repress, as a percentage of the calibrated range.
Draft only. Turn Developer mode off and release M1 before applying. Settings are RAM-only: reboot or a wired/wireless transport reset restores defaults.
Signal trace
No data sourceStart simulation to explore the controls.
No live M1 values are being received.
PAW3950
Device-timed captures and wired settings · your current DK sensor
Mouse settings
Connect and read first. Applying settings is an explicit USB write; keep the mouse idle.
Not connected. The values above are draft defaults, not device readings.
Live motion
20 Hz displayConnect compatible mouse firmware and enable Developer mode. Missing data is not shown as zero.
- Cumulative X
- —
- Cumulative Y
- —
- Digital M1 / M2
- Device time
- —
- Sensor state
- —
- Publication sequence
- —
Counts already published by the sensor core, observed by the MCU. Not optical frames or a surface-to-host latency measurement.
Device capture
Capture into mouse RAM, then download. Live streaming pauses during capture.
8192 samples maximum. Download switches Developer mode off first.
Leave this tab visible during a run. Closing it or losing keepalive stops diagnostics within 5 seconds. Turn Developer mode off for performance testing; enabled diagnostics add work.
Recordings
Inspect sample intervals and signals. Intervals are not motion latency.
Session library
Local to this tab · export before closing| Name | Source | Samples | Action |
|---|
No recordings yet. Record a simulated M1 press, or import timestamped CSV data.
Recording
IMU
LSM6DSOX · acceleration and rotation · M2 stays digital
Magnetometer
LIS2MDL · field measurements, calibration and interference
Help & data
Device diagnostics and M1 calibration.
Enable JavaScript to use this local-device dashboard. Browser data is not uploaded.